Two-Toned Layered Pendant

ImpressArt Tutorial

Tools Needed

ImpressArt tools tutorial

Step 1

Stamp the word “be” on the brass blank using the stamp straight tape

    • Place tape on blank
    • Mark where each letter will be stamped with a permanent marker
    • Drag stamp until it meets the top of the tape
    • Strike the stamp once with medium force to stamp each letter

Watch Stamp Straight Video for more.

ImpressArt Stamp Straight Tape

Step 2

Stamp the word of your choice in the center of the pewter blank using the stamp straight tape

  • Mark tape
  • Place brass blank on top to make sure the word will be covered
  • Stamp each letter by striking the stamp once with medium force

ImpressArt Tutorial 2 Layer pendant

Step 3

Use stamp enamel on the word stamped on the pewter

  • Cover the impression with stamp enamel
  • Use the Q-tip to ensure the enamel completely covers the impression
  • Wait 10-20 seconds
  • Blot with a soft cloth
  • Wipe away the excess stamp enamel with a soft cloth

ImpressArt Stamp Enamel

Step 4

Open the jump ring using two pairs of pliers

ImpressArt Tutorial Jump Ring

Step 5

Slide both blanks onto one end of the jump ring

ImpressArt 2 layer pendant tutorial

Step 6

Close the jump ring

ImpressArt 2 layer pendant jump ring

Step 7

Slide the chain through the jump ring

ImpressArt 2 layer pendant finished piece